Gtechniq – Crystal Serum Light

• To apply Crystal Serum Light (CSL) make sure your vehicle is indoors and can stay indoors for 12 hours after application, do not apply in direct sunlight
• Only apply the product at a temperature between 5°c and 25°c
• Shake well and wear gloves
• Wash and decontaminate your paintwork thoroughly prior to application. If required, polish your paintwork, either by machine or hand, to remove any imperfections
• Spray Panel Wipe into a Gtechniq MF1 Microfibre Cloth and wipe down each panel in small sections
• Soak the application pad with 3 full measures of CSL from the pipette and work the liquid into the pad to get an even saturation
• Replace the lid on the bottle and set it aside – do not keep the bottle in your hand as this promotes premature curing
• Apply in overlapping strokes to an area roughly 2ft by 2ft (60cm x 60cm)
• Immediately remove residue with an MF1 cloth – you may need to buff the same area several times, but avoid doing it with too much force. We recommend the use of 2 cloths at any one time. Make sure the cloths are rotated during residue removal to prevent CSL curing in the cloth
• Inspect the surface for residue with a bright, diffused light source
• If you have removed the residue and it cures fully, you should polish the area and reapply CSL
• As soon as you finish, put your MF1 cloths in water, wash and dry them as soon as possible
• Wait a minimum of 1 hour after applying CSL before applying EXO Ultra Durable Hydrophobic Coating, or C2 Liquid Crystal
• Store in a cool, dry place
• If opened, use within 3 months, if unopened, use within 12 months

* Avoid direct application to plastic trims, rubbers and hard plastics. *